![]() For SA Lifetime (seconds 120-604800), enter the time in seconds before the key must be re-established with the network.For IKE1, Perfect Forward Secrecy ( PFS) is enabled, and you can select a Diffie-Hellman (DH) group algorithm.(Optional) Set up your Phase-2 settings:.(Optional) To periodically check the connection and attempt to reconnect if the connection goes dead, check the box next to DPD (Dead Peer Detection) and enter a time interval between checks in seconds under DPD Interval (seconds 1-300). ![]() For SA Lifetime (seconds 60-604800), enter the time in seconds before the key must be re-established with the network.Responder Mode: The BR500 can respond to an IKE request from the remote VPN router.Initiator/Responder Mode: The BR500 can both initiate a connection to the remote VPN router and respond to an IKE request from the remote VPN router.For the Negotiation Mode, select Initiator/Responder Mode or Initiator Mode.Aggressive Mode is only available on IKEv1. For the Exchange Mode, select Main Mode or Aggressive Mode.You must use the same algorithms on both VPN routers. Next to one or more Proposals lines, select an algorithm.(Optional) Set up your Phase-1 settings:.However, you can customize these settings for different network or security configurations. You can set up a VPN IPSec tunnel without changing these settings. If you need to customize the Phase 1 and Phase 2 settings, click Advanced Settings.Enter a pre-shared key for the IPSec policy.The pre-shared key must be the same for both routers in the site-to-site VPN. ![]() Enter the LAN IP subnet address and mask of the BR500 router.Enter the LAN IP subnet address and mask of the remote VPN router.Enter the WAN IP address or fully qualified domain name (FQDN) of the remote VPN router.Click the Add button.The IPSec policy settings appear on the right.On the router dashboard, select ADVANCED.The user name and password are case-sensitive. If you did not change your router's password during setup, enter password. Enter the router user name and password.On a computer or mobile device that is connected to your BR500 router's network, access." messages, and it never finishes.There doesn't seem to be any place to enter the Remote and Local IDs, or at least the how-to didn't describe where.I'm attempting a connection where a laptop behind a consumer-grade NAT router (DynDNS client, LAN network 192.168.1.0) is trying to connect to the public static IP of the FVS338 and get access to the 192.168.0.0 network behind it.To set up an IPSec VPN tunnel on your BR500 router: When I get to the ping test, I just get an endless stream of "Negotiating IP security. I tried following this guide, (manually creating a suitable security policy on the Local Computer in XP) but I can't get it to work. Also, reviews of NetGear's client are pretty negative. In general I like to install as little stuff as possible on these computers. ![]() But I'm trying to see if it's possible to set it up with the built-in XP stuff. I also got it to work with the trial version of the GreenBow client for XP. I've gotten this working with the free OS X client IPSecuritas, so the router is set up correctly. I figured this was a good time to get rid of our NT Server-based PPTP VPN and set up hardware-based IPSec tunnels. We just got our first T1 installed and I put a Netgear FVS338 behind it for NAT.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |